Customer case aboutflotation of copper slag in lesotho

flotation of copper slag in lesotho

RECOVERY OF COPPER FROM COPPER SLAG AND COPPER

Recovery of copper from copper slag and copper slag flotation tailings 75by oxidative leaching Table 1. Chemical compositions of the copper smelter slag and the slag flotation tailings Constituent Content (wt.%) Copper Slag Slag Flotation Tailings Cu total 0.97 0.59 Cu oxides 0.15 0.06 Cu sulphides 0.82 0.53 SiO 2 33.75 34.62 Al 2 O

COMPARATIVE RESULTS OF COPPER FLOTATION FROM

Production of copper concentrate by flotation of smelter slag has started in 2001. Flotation concentrate goes to the Copepr Smelter once more for production of cop-per cathodes and the rough flotation tailings go to the flotation tailing dump. Copper recoveries in the flotation process of smelter slag reaches the value of about 45- 50%.

Optimization of the flotation of copper smelter slags from

Optimization of the flotation of copper smelter slags from Namibia Custom Smelters’ Slag Mill Plant Elias Sipunga A research report submitted to the Faculty of Engineering and the Built Environment, University of the Witwatersrand, in partial fulfillment of the requirements for the degree of Master of Science in Engineering

2-Recovery of Copper and Cobalt from Converter Slag with a

Key words: Converter slag, flotation, copper, cobalt, sulphurization. 1. Introduction Copper slag is produced in large amounts in seven copper smelter plants in Chile, and it is estimated that around 4 million tons of slag are disposed every year and another

RECOVERY OF COPPER FROM SMELTING SLAG BY

flotation of slag tailings using sulphuric acid solutions, without or with the addition of either ferric sulphate or hydrogen peroxide. However, the maximum copper extraction attained with the slag was modest at about 63%, whereas that obtained with the slag flotation tailings was as low as 33% (Urosevic et al., 2015). Accordingly, the objective

Recovery of metal values from copper slags by flotation

A fayalitic-type of ancient copper slag containing 1.24% Cu, 0.53% Co and 53.16% Fe were subjected to an experimental study. Two different routes were followed to recover the metal values. The...

JME

Copper recovery from the secondary copper slag by the flotation method is an alternate route [12]. The partial enrichment of Sn and Ni is also possible by this method. A flotation scheme used at the Almalyk copper smelter for the processing slags together with Cu-Mo ores was described, and the ways to optimize the slag flotation process

[PDF] Recovery of copper from the copper slag and copper

Copper smelter slag and copper smelter slag flotation tailings were leached using sulphuric acid solutions, without or with the addition of either ferric sulphate or hydrogen peroxide. Copper extraction from the slag was typically found to be twice as high as that from the slag flotation tailings. Hydrogen peroxide was determined to be the best lixiviant. Thus, copper and iron extractions were

The Recovery of Copper from Smelting Slag by Flotation

Abstract. Aiming at the recovery of copper from smelting slag, a flotation approach was studied. It was found that this slag composed of fine particles with complex association and distribution, in which bornite was the main copper-bearing mineral after a detailed mineralogy analysis via

COMPARATIVE RESULTS OF COPPER FLOTATION FROM

Production of copper concentrate by flotation of smelter slag has started in 2001. Flotation concentrate goes to the Copepr Smelter once more for production of cop-per cathodes and the rough flotation tailings go to the flotation tailing dump. Copper recoveries in the flotation process of smelter slag reaches the value of about 45- 50%.

THE EFFECT OF COOLING RATE OF SLAG FROM PRIMARY

Apr 05, 2015 The content of copper in the flotation tailings directly depends on fragmentation rate (Figure 1). Expected content of copper in the flotation tailings, in the case of cooling in pits, is 0.5-0.9%, and in the case of cooling in pots, from 0.22 to 0.35% Cu. Fig. 1. The effect of fragmentation rate on the slag flotation [6]

2-Recovery of Copper and Cobalt from Converter Slag with

Key words: Converter slag, flotation, copper, cobalt, sulphurization. 1. Introduction Copper slag is produced in large amounts in seven copper smelter plants in Chile, and it is estimated that around 4 million tons of slag are disposed every year and another

Enhancing the flotation recovery of copper minerals in

The cumulative copper recoveries increased markedly to over 90%, which represents a significant improvement in comparison to the recoveries obtained from the mill-float process. Sodium alkyl dithiophosphate, mercaptobenzothiazole (FC7245) was found to be the secondary flotation reagent that gave the best copper recoveries.

JME

Copper recovery from the secondary copper slag by the flotation method is an alternate route [12]. The partial enrichment of Sn and Ni is also possible by this method. A flotation scheme used at the Almalyk copper smelter for the processing slags together with Cu-Mo ores was described, and the ways to optimize the slag flotation process

SUSTAINABILITY OF COPPER SLAG PROCESSING FROM

Flotation is an important technology to recover copper from copper slag. There are a few industrial flotation facilities for treatment of copper slag, such as: Magma Copper San Manual facility, USA, Altonorte Flotation Plant, Chile, Outokumpu facility, Finland,

Recovery of Copper from Copper Smelter Slag by Flotation

The recovery of copper from copper smelter slag utilizing flotation has been studied. A copper smelter slag from the Wang Jiaqiao smelter in Yunnan Province of china, containing 2.76% Cu, 44.41% Fe, 2.34% Zn and 18.4g/t Ag and so on, has been used .The effective factors such as grinding fineness, pH, and the dosage and type of collector were examined.

Copper Sulfide Flotation Mineral Processing & Metallurgy

Mar 19, 2017 The above flowsheet is designed for the treatment by flotation of copper as chalcopyrite with gold and silver values. The ore, ranging from 60-65% silica, with pyrite, arsenopyrite, and calcite with 3 to 4% copper. This flowsheet, though simple, is

THE EFFECT OF COPPER SULPHATE ON FROTH STABILITY

confirmed adsorption of copper sulphate onto the pure mineral surfaces and it was assumed the cations in synthetic plant water also adsorb onto the mineral surfaces in a similar manner. For the UG2 ore, in addition to copper hydroxides forming on the mineral surfaces, chemically reacted copper was also found on the mineral surfaces using the EDTA

OUTOTEC FLASH SMELTING TECHNOLOGY

Outotec Slag Cleaning Slag cleaning at copper and nickel smelters is typically done using an electric furnace process. The design of Outotec slag cleaning furnaces is based on our extensive experience with different slag compositions and under-standing of how to optimize the process for maximum recovery.

Copper extraction Wikipedia

Slag is less dense than matte, so it forms a layer that floats on top of the matte. Copper can be lost from the matte in three ways: as cuprous oxide (Cu 2 O) dissolved in the slag, as sulfide copper dissolved in the slag or as tiny droplets (or prills) of matte suspended in the slag.

(PDF) Expansion of the Mount Isa Mines Copper Concentrator

The best result for the fourth slag (low copper self-pulverising slag) was 74% copper recovery. Coarse copper metal was present in the flotation tails for this test suggesting the pre-flotation

Recovery of Copper and Silver by Flotation from Smelting

The recovery of copper from smeltery furnace slag by flotation has been studied. By analysis the slag containing 1.61% copper and 27.80g/t silver is available to recovery. The effective factors such as particle size, the amount and type of collector were examined. The combination of the collectors was also examined. With the process utilized in this work, a copper concentrate of 26.47% Cu with

The Recovery of Copper from Smelting Slag by Flotation

Abstract. Aiming at the recovery of copper from smelting slag, a flotation approach was studied. It was found that this slag composed of fine particles with complex association and distribution, in which bornite was the main copper-bearing mineral after a detailed mineralogy analysis via

Copper extraction Wikipedia

Slag is less dense than matte, so it forms a layer that floats on top of the matte. Copper can be lost from the matte in three ways: as cuprous oxide (Cu 2 O) dissolved in the slag, as sulfide copper dissolved in the slag or as tiny droplets (or prills) of matte suspended in the slag.

THE EFFECT OF COOLING RATE OF SLAG FROM PRIMARY

Apr 05, 2015 The content of copper in the flotation tailings directly depends on fragmentation rate (Figure 1). Expected content of copper in the flotation tailings, in the case of cooling in pits, is 0.5-0.9%, and in the case of cooling in pots, from 0.22 to 0.35% Cu. Fig. 1. The effect of fragmentation rate on the slag flotation [6]

Copper Sulfide Flotation Mineral Processing & Metallurgy

Mar 19, 2017 Flowsheet for treatment of Copper Sulfide ores rich inminerals such as chalcopyrite with gold and silver as well as arsenopyrite. The above flowsheet is designed for the treatment by flotation of copper as chalcopyrite with gold and silver values. The ore, ranging from 60-65% silica, with pyrite, arsenopyrite, and calcite with 3 to 4% copper.

Recovery of Copper from Copper Smelter Slag by Flotation

The recovery of copper from copper smelter slag utilizing flotation has been studied. A copper smelter slag from the Wang Jiaqiao smelter in Yunnan Province of china, containing 2.76% Cu, 44.41% Fe, 2.34% Zn and 18.4g/t Ag and so on, has been used .The effective factors such as grinding fineness, pH, and the dosage and type of collector were examined.

Recovery of Copper from Reverberatory Copper Slag and

possible option. The copper slag contains a high content of silica and iron. The solution final pH is the most important factor affecting the removal of iron and silica from the leach solution and the overall metal recovery. Fe removal from the leaching of copper slag is done by the formation of a metal hydroxide.

Management of copper pyrometallurgical slags: giving

Some properties of a typical copper slag are shown in Table I, and it can be observed that air-cooled copper slag has a black colour and glassy appearance. The specific gravity varies with iron content, from 2.8 to 3.8. The unit weight of copper slag is somewhat higher than that of conventional aggregate. The absorption capacity of the

(PDF) Expansion of the Mount Isa Mines Copper Concentrator

The best result for the fourth slag (low copper self-pulverising slag) was 74% copper recovery. Coarse copper metal was present in the flotation tails for this test suggesting the pre-flotation

TACKLING IMPURITIES IN COPPER CONCENTRATES

Table 3 Chemical Analysis of Mercury-Bearing Copper Concentrates Element Concentrate “A” Concentrate “B” Cu 26 20 Fe 26 27 S 28 38 As + Sb 0.1 4.1 Zn 0.1 5.5 Hg, ppm 200 430 The principal mineralogy of the two concentrates is shown in Table 4.

OUTOTEC FLASH SMELTING TECHNOLOGY

Outotec Slag Cleaning Slag cleaning at copper and nickel smelters is typically done using an electric furnace process. The design of Outotec slag cleaning furnaces is based on our extensive experience with different slag compositions and under-standing of how to optimize the process for maximum recovery.

Recovery of Copper from the Slag of Khatoonabad Flash

Copper loss in the slag of Khatoonabad flash smelting furnace is estimated to be about 1-3 %. At present, the electric slag cleaning furnace is used for the recovery of copper from slag. However, due to low recovery efficiency of electric furnace along with high consumption of electrical energy and water, selection of a method to enable minimum energy consumption and maximum recovery of copper

Recovery of Copper and Silver by Flotation from Smelting

The recovery of copper from smeltery furnace slag by flotation has been studied. By analysis the slag containing 1.61% copper and 27.80g/t silver is available to recovery. The effective factors such as particle size, the amount and type of collector were examined. The combination of the collectors was also examined. With the process utilized in this work, a copper concentrate of 26.47% Cu with

Froth flotation Wikipedia

Froth flotation is a process for selectively separating hydrophobic materials from hydrophilic.This is used in mineral processing, paper recycling and waste-water treatment industries. Historically this was first used in the mining industry, where it was one of the great enabling technologies of the 20th century.

SUSTAINABLE RECOVERY OF BY-PRODUCTS IN THE MINING

phase, the slag. In most copper extraction processes, matte is an intermediate phase. The pyrometallurgical production of copper from sulfide ore concentrates is a rough separation of the three main elements as crude copper, iron (II) silicate slag, and sulfur dioxide. Slag containing <0.8 wt% copper are either discarded as waste or sold as

Booking Online

#